position of fault

英 [pəˈzɪʃn ɒv fɔːlt] 美 [pəˈzɪʃn əv fɔːlt]

网络  故障位置

化学



双语例句

  1. Together with the operation experience, the type and position of transformers fault can be determined correctly through comprehensive analysis on the data of electrical test and gas chromatography.
    结合平时的运行经验,对电气试验和气相色谱分析数据进行综合分析,可以比较准确地判断变压器故障类型和故障部位。
  2. By means of analysis of force of large scale ore dressing equipment cone crushers, the position and mechanism of fault as well as problems needing attention in the course of design and making were raised, so as to guarantee the machine to work smoothly.
    通过对大型选矿设备&圆锥破碎机的受力分析,说明其频发故障的部位和机理,为保证机器的正常运转,在设计、制造中应当注意的问题。
  3. The reservoirs in updip and downdip direction in the low position and the high position of warped fault blocks are predicted.
    据此,分别对翘倾断块低部位的上倾方向、下倾方向,以及翘倾高部位进行了储层预测。
  4. Through the analysis of vent gas it can diagnose the position of engine fault, which was verified by the real fault example.
    指出通过尾气分析可诊断出发动机故障所在的部位,并通过故障实例得到了验证。
  5. Constituting the interpolating curves by use of fuzzy values, according to the relative position of the interpolating curves the fault pattern can be determined and the faulty position is equal to the minimum of the curve from the determined fault pattern.
    用模糊值构成插值曲线,根据曲线的相对位置确定故障模式,并由曲线的最小值求得故障距离。
  6. This paper focused discussion on oil control model of fault segmentation and oil control mode and its controlling mechanism to remaining oil enrichment. In accordance with different fault development position and mechanical mechanism, four oil control models of fault segmentation were built.
    文章重点论述了断层分割控油模式及对剩余油富集的控制机理,依据断层发育部位和力学机制不同建立了4种断层分割控油方式;
  7. A procedure to diagnose single faults in SRAM based FPGA's is presented in the paper, which is nonadaptive and requires six programming steps to give the exact position and type of any single fault in a FPGA.
    提出了一种诊断基于SRAM的FPGA的连线故障的方法,该方法通过六次编程可把任何FPGA连线资源的单故障定位到最佳精度;
  8. The feature of fault signal, which is obtained by singular signal inspection, signal noise separation and signal frequency range analysis by means of wavelet analysis, can be used to identify the position and intensity of the fault.
    为此提出用小波分析方法,通过对奇异故障信号的检测、信噪分离和信号频带分析来提取故障特征,以确定故障的位置和程度。
  9. With associated Rayleigh Wave Method to detect fracture plane, the attitude, character, position and displacement of small magnitude fault can be forecasted accurately.
    若配合利用瑞利波探测法探测断裂面,可以对小断层的产状、性质、位置、断距进行准确预报。
  10. The system, which serves the function of characteristic parameter analyzing, time-frequency distribution, fault intelligent diagnosing and so on, is capable of diagnosing position, quality, extent of fault effectively.
    该系统具有特征参数分析、时频分布、故障智能诊断等功能,能有效地诊断出轴承故障发生的部位、性能和程度等。
  11. The results of MT clearly reflect the characteristics of electrical structure of the crust and upper-mantle, such as shape and boundary of tectonic units, position of fault, development of the high conductive layer in the crust and upper-mantle etc.
    大地电磁测深的结果清楚地反映了剖面内地壳和上地幔的电性结构特征。例如构造单元的形态、边界、断层位置、地壳和上地幔的高导层发育情况等。
  12. According to the interception relationship of it with the relative movement force of two walls and the special position of the relative movement force on the fault plane, the 3 general rules and 3 special rules can be induced.
    它和两盘相对运动力的相交关系及相对运动力在断层面上的特殊位置,可以得出岩层错动和相对运动之间三条普遍规律和三条特殊规律。
  13. The dynamic variation of the Radon-density in soil with the lapse of time has been obtained from surveying at fixed position in Beichuan area along the middle part of the Longmenshan fault zone.
    在龙门山断裂带中段的北川地区进行了土壤氡浓度随时间的动态变化定点观测。
  14. The southwest fault step zone and the position of intersection of fault F_1 and the northeast basin-marginal fault are favorable sites for looking for potential sandstone reservoirs.
    西南断阶带和F1断裂与东北盆缘断裂交汇处是寻找砂岩油气藏的有利区域。
  15. Both the determination of coordinate and mapping space position of active faults in city are important tasks in fault surveying.
    测定活断层的坐标、绘制活断层空间位置分布图,是城市活断层探测的一个重要目的。
  16. The strike, dip, dip angle and position of a fault can directly been gotten by GPR records profiles, but the method cannot be used to describe the features of the fillings in fault plane.
    通过雷达记录剖面可以直接探测得到断层走向、倾向、倾角及位置,但不能查明断层面内充填物的具体情况。
  17. Use the classical bridge method to test the position of the insulated fault point, adopt high voltage and high performance electronic amplifier to substitute galvanometer extend the measuring range of the insulation resistance to 10M Ω.
    利用经典电桥法对电缆绝缘故障点位置进行测定,采用高电压、高性能电子放大器代替检流计使测量范围延伸到高达10MΩ的绝缘故障测量。
  18. The conditons for groundwater are the tectonic unit, the strike, distance, position of the fault near wells, the depth of the well and lithologic property and groundwater type of the aquifer.
    影响地下水类观测井映震能力的主要条件是构造单元、邻近断裂的走向、距离、部位、井深、含水层的地层岩性与地下水类型;
  19. The fault trees analysis technology is used in the photovoltaic radar electronic equipment fault diagnosis, and the fixed position method of fault component is discussed.
    将故障树分析技术引入光电雷达电子设备故障诊断之中,讨论了故障元件的搜寻定位方法;
  20. And simulation results show its feasibility. Then analyzed the reasonable install position of the new wiring way fault current limiter in mine power supply system, and to explore the influence on the original relay of mine power system.
    然后分析新型接线方式的限流器在矿山供电系统中的合理安装位置,探讨了短路限流器对矿山供电系统中原有继电保护的影响。
  21. The study shows that, when the position of fault point and the zero-sequence parameter of system meet certain conditions, the zero-sequence current of non-fault line will be greater than that of fault line, and here, the protection will probably not meet selective requirements.
    分析表明当故障点位置和系统零序参数满足一定条件时,非故障线路上的零序电流将大于故障线路上的零序电流,此时保护可能无法满足选择性的要求。
  22. Simulated the common failure of electro-hydraulic position servo system. obtain fault simulation curve samples of common fault of the servo valve.
    对电液位置伺服系统的常见的故障做了仿真,获取了常见伺服阀故障的故障样本仿真曲线。
  23. In order to solve for different bearing fault classification problem, according to the characteristics that maximum between-class discrete degrees and minimize within-class discrete degrees, it can classify different position of the fault and the same position different sizes of the fault.
    为了解决对不同轴承故障进行分类的问题,提出利用费舍尔判别分析在分类中最大化类间、最小化类内离散度的特点,可以对不同位置的故障以及相同位置不同大小的故障进行分类。
  24. The DGA is used as dominant idea to diagnose internal incipient fault in this model. Synthetical diagnosis on the basis of combining all kinds of relevant tests makes a decision for the fault position; improves the reliability and accuracy of fault diagnosis.
    该模型以油中溶解气体分析作为诊断内部潜伏性故障的主线,结合各种相应的试验项目进行综合诊断,确定了故障的大体部位,提高了故障诊断的可靠性和准确性。
  25. Finally, the actual circuit will be used to extract fault feature and fault diagnosis. The simulation and results show that the program can achieve the fault and position of fault component, and achieve higher fault diagnosis rate.
    最后结合实际电路进行故障特征的提取和故障诊断,通过仿真实验和结果分析表明,本文诊断方案能够实现故障元件的检验和定位,并且达到较高的故障诊断率。
  26. The plan through different position of fault direction components, can compare movement state conveniently, determine the position of the breakdown of the fault accurately, in order to realize the rapid resection, ensure the normal running of the fault part.
    这一方案通过对不同位置故障方向元件动作状态的比较,能够方便、准确地确定出故障点的位置,以实现对故障部分的快速切除,确保非故障部分的正常运行。
  27. Cable accessories have become a weak link and a typical position of the most high cable line insulation fault.
    电缆附件已经成为高压电缆线路绝缘的最薄弱环节和运行故障的典型部位。
  28. The experimental simulation results prove that the method of this fusion system have strong fault tolerance, and can make full use of sensors 'information and fix the position of fault accurately.
    通过仿真证明:该信息融合算法容错性强、能综合利用传感器信息并准确定位故障。
  29. The exploitation of fault block reservoir is very important in China. The dominant position of the fault block reservoir in the fault basin of eastern china.
    断块油藏是我国油田开发中占重要地位的一类油藏,在我国东部的许多断陷盆地油藏中,断块油藏占有主导地位。
  30. Therefore, determining the law liability of ownership of trademark infringement should base on the dominant position of no fault principle context, liability without fault should be fully identified the dominant position of principle. According to the law, the seller should not take law responsibility.
    因此,笔者认为,在侵犯商标权的法律责任确定方面,应全面确定无过错责任原则的主体地位,严格按照法律规定免除销售商的相应法律责任。